I finally succeed connecting Arduino and Isadora.
This is today's goal, so I am happy.
Basically, I analyzed a source for Arduino made by somebody.
I prepared hardware based on a example that is shown in a tutorial of the Arduino webpage.
http://arduino.cc/en/Tutorial/Button
And then move to the Isadora and setup USB port.
make sure that the seep is set properly and choose right connection(in this case COM3).
Sometime Isadora can not find the USB connection since other software uses it.
In such case , most of the time Arduino programing software using the connection so just close it.
However, somehow it is still unstable, and Isadora was dead couple times.
More experiment result check video.
The sources are come from below link
0 件のコメント:
コメントを投稿